Tag Archives: DIY crayons

DIY: Custom Crayons

What you’ll need:

– Razor or Exacto knife

– Knife

– Cutting board
(you may want to use a cutting board or other solid
surface you don’t mind ruining)

– Cookie Sheet

– Aluminum Foil

– Crayons

– Oven safe silicone mold(s)
(I got mine for 99 cents each from Ikea. Yes, only 99 cents!!!)

– Toothpicks

Step 1

Using a razor or Exacto knife carefully slice the crayon wrapper then remove. Repeat until the number of desired crayons is reached. I found it easiest to hold the crayon at the top (as shown in the top, right picture below) and slice the wrapper in one straight line.

*If you’re using a new pack of crayons the wrappers of certain colors will be a little trickier to remove. I’d suggest popping them into the freezer for about 15 minutes before you begin the unwrapping process. The slight freeze allows for easier removal.*

Step 2

Begin cutting the unwrapped crayons into small pieces. The pieces should be around ¼ of an inch or smaller. This will allow the pieces to fit into the forms small cracks.While cutting up the crayons I started off using one method but that was taking quite a bit of time so I switched to another. Listed below are both methods I used while cutting the crayons.

Method #1

Place a crayon onto the cutting board and hold as seen in the first photo below. Begin sawing at the crayon while applying pressure downwards. You should only need to saw a bit before it breaks into a small piece.

Method #2

Place a crayon onto the cutting board. Hold the knife as shown in the first picture below then apply pressure directly onto the index finger using your other hand (as shown in the second picture below). Be careful with your thumb placement during this method so it doesn’t get caught under the end of the knife.

I found this method more effective because it was the faster of the two.

Step 3

Once the desired amount of crayons have been cut, you can begin filling your silicone mold(s). This is the part where you let your creativity and imagination take hold. Play around with different patterns and color combinations to make each crayon unique. You’ll want to overfill the forms slightly so when the crayon pieces begin to melt it’s entirely filled with melted wax.

Step 4

Once desired amount of forms have been filled place the mold onto an aluminum foiled covered cookie sheet.

Step 5

Place cookie sheet into a 250 degree oven for 12-15 minutes. Time and temperature may vary slightly oven to oven.

*You basically just want to bake until all the crayon pieces have melted. I’d suggest checking the mold around the 10 minute mark and see how it’s doing.*

Step 6

Once all the crayon pieces have completely melted remove the cookie sheet from the oven. Using a toothpick pop any air bubbles you see on the surface of the melted wax.

*This step is kind of optional. If the air bubbles are not popped you just won’t have as smooth of a surface on the new crayons.*

Step 7

Carefully carry the silicone mold and place it into the freezer for 20 minutes. Try to avoid spilling the melted wax because obviously, it will burn if it gets onto your skin. After 20 minutes the new crayons should be completely hardened, as well as cool.

Step 8

After 20 minutes remove the mold from the freezer and set aside until it reaches room temperature. This step will help the new crayons release easier.

Step 9

Flex the mold back and forth a bit to loosen the new crayons. Once the crayons have been loosened, flip the mold over and start popping them out. You’ll want to do this with a careful hand so they don’t break when they’re released.

Repeat until all the crayons have been released and you’re done!

Since these crayons are so adorable and would make a great gift I decided to add on a quick and easy wrapping option.

What you’ll need:

– Small treat bags

– Ribbon

– Scissors

– Crayon

All you do is place a crayon into the small treat bag then tie off the top with a ribbon.

This craft is really inexpensive, easy, and I honestly had fun making them. I really hope you all will give it a shot. I also tested it out with the kids I nanny the next day, and they had a blast. Look for pictures from that day in August’s Nanny Bits post at the end of the month.

Give my tutorial a try? Leave a comment. I’d love to hear whether or not it worked out for you and what you came up with.

– Katie

Here are my casualties from the project: R.I.P. little fishes.



Filed under DIY and Crafts